Go Cart Race Page
Buy, sell, trade, rent => Wanted => Topic started by: Codyjones on November 16, 2017, 09:36:09 am
-
After this year and the few races i attended i decided to buy a cart. i actually bought 2 frames one in better shape than the other. I am going to build the motors this winter and restore the frames for races next year.
Im looking for a few different things listed below:
* Briggs 5hp I/C / Raptor blocks with stock piston short block preferred
* Briggs flathead high tension valve springs 30-38lbs
* Cheap sprockets in decent condition
* Clutch with disk and fingers (bully, ect)
* Billet 5hp briggs flywheel or 3hp flywheel
* Spindles with bearings
I have a complete Flathead I would sell for $150, may have a block also on hand.. I also have a billet flywheel, ARC #6608 Retail $175 new I can sell for $75 used.. I have valve springs but not sure their strength, look heavy duty like two springs in one.. Also have other Flathed parts, ARC #6598 Stroker crank ($447.95 new) ARC #6348 Billet Rod ($60 new) Burris piston #BSF-202-50 Piston .050 overbore, Dyno Cams #116-C Camshaft ($160 new) Clement Billet head, and a Competition Carbs HL-368A-919 Carburator brand new.. Can sell all this for $650, I am thinking of having a badass flathead built with these parts :) Thanks.. Also have clutch drivers and rear sprockets also...
-
Ive talked to Danny. These are parts especially the heavy valve springs are important to my engine build. If anyone can help id greatly apperciate it! Ill post pictures soon of the engine build if i can do that on the forum.
-
I also passed your list to Larry, he might be able to help you out also.
-
Danny S might have some of these parts
-
After this year and the few races i attended i decided to buy a cart. i actually bought 2 frames one in better shape than the other. I am going to build the motors this winter and restore the frames for races next year.
Im looking for a few different things listed below:
* Briggs 5hp I/C / Raptor blocks with stock piston short block preferred
* Briggs flathead high tension valve springs 30-38lbs
* Cheap sprockets in decent condition
* Clutch with disk and fingers (bully, ect)
* Billet 5hp briggs flywheel or 3hp flywheel
* Spindles with bearings
Also looking for a clone race go kart rolling frame. The 2 carts i bought are 1960's vintage race carts. They look like the Rupp Lancer carts. Ones actually a dual motor frame and other is single. They are in good condition and would consider trading for cart with side motor frame.